ToFN LED STOCK DUE LATE FEB, ORDERING A KIT WITH ToFN WILL DELAY YOUR ORDER UNTIL THEY ARRIVE.

This kit includes most of the parts needed to complete an installation on a Gaggia Classic Pro (NOT Gaggia Classic).
You will need to fabricate your own high voltage wiring and use the included JST Kit to wire the low voltage side.

BLACKPILL FULLY SOLDERED
BLACKPILL & SCREEN PROGRAMMED

KIT INCLUDES

• Official Gaggiuino V3 PCB – Professionally produced PCB, with all required components installed and soldered to both sides of the board.
• Blackpill
• 2.4″ Screen HMI Touchscreen (TJC Blue PCB)
•  JST Pigtail Kit. This can make wiring things in easier and avoids the need to crimp small connectors. Includes. 3 x 3P 2mm leads 1 x 4P 2mm lead 1 x 4P 2.54mm lead (Nextion) 1 x 5P 2mm lead
• Pressure Sensor ( 1.2Mpa )
• O-Ring for Pressure Sensor Adapter
• Thermocouple K – M4
• Transducer Barb Fitting (6mm stainless steel)
• T-fitting (6mm stainless steel)
• 4 x Hose Clamps
• Genuine SAECO silicone hose (13cm Length)
• SSR  40DA
• USB STLink Tool

Options available.

• Dual Scales PCB. Only needed if you plan to add physical scales to your build. Populated dual Scales (HX711). This eliminates the need to purchase two HX711 boards, you still need load cells.
• ToFnLED Kit. Add water level monitoring and an RGB LED.

Installation resources can be found HERE

PCB colour may vary, current is purple.